Dimension

A dimension is a size that controls the sketch. You draw a shape roughly, then dimension it: when you type a size, the drawing changes to match. So the sketch is exactly the right size, however roughly you drew it. Each dimension also stops part of the sketch from moving, which turns it from blue towards black (fully defined: see Sketch).

How to use it#

1. In a sketch, click Dimension, or press D.
2. Click what you want to measure (see the table below).
3. Move the pointer to where the size should sit. A preview shows the size you will get.
4. Click to place it, type the size and press Enter.

The tool stays on, so you can dimension one thing after another. Press Esc when you have finished.

What to click#

Points include the origin, the ends of lines and the centres of circles. You can also measure to the dashed orange edges and corners of parts, so a sketch on a face can be placed from the part's edges.

Typing sizes#

• A plain number is in millimetres: 120.
• Sums work: 600-2*19 is worked out to 562.
• Other units are changed to mm: 2 in, 5 cm, 0.3 m.
• The name of a parameter, such as t or t*2, stays linked: change the parameter and the sketch follows. The dimension then shows the name too, such as t = 12.
• Angles are in degrees, between 0° and 180°.

Changing a dimension#

• Double-click a dimension to type a new size.
• With Select, drag a dimension's number to move it somewhere tidier.
• To delete a dimension, click its number and press Delete.
• You do not have to open the sketch: click the sketch in the feature tree and its sizes show on the model. Click one to type a new size, or drag its arrow.

Fully defined#

Each dimension takes away one way the sketch can move. The message at the top of the view counts what is left, such as Under-defined: 2 more dimensions or constraints needed (blue can still move). Use dimensions for sizes, and constraints for rules such as horizontal or equal. Remember to tie the shape to the origin: start it on the origin, or dimension from the origin to a corner.

Tips#

• Dimension the biggest sizes first (the overall length and height), then the small ones.
• If the shape jumps into a strange shape when you type a size, press Ctrl+Z, drag it closer to the size you want, and type the size again.
• Use a parameter for a size that repeats, such as the board thickness t.

If it does not work#

• That size is already fixed by other dimensions or constraints, so it would over-define the sketch. Something already sets that size. If you want this dimension instead, delete the other dimension or constraint first.
• The sketch cannot take that size with its other dimensions. Try another value. The new size fights the others. Check the other sizes.
• Pick a line, a circle, or two points to dimension. You clicked something a dimension cannot measure, such as a part's edge on its own.
• "w" is not in your parameters table (with your own name in place of w): check the spelling, or add the parameter under Parameters.
• A red dashed edge: after a change to an earlier feature, a dimension lost the part edge it was measured from. Click the red dashed edge, then the edge to use now. Or click Remove in the message that shows when the sketch opens, and add a new dimension.